Mainboard Setup
Before installing the mainboard, there are a few preparation steps to ensure everything fits and works as expected.
Sanity Checks
If you have already printed out the Electronics Box, you can:
- Align the mainboard with the electronics box and confirm:
- (If using a Manta M5P) The pin in the top left aligns with the mounting hole.
- All three other mounting holes are alligned.
- If all is aligned, proceed. Otherwise, troubleshoot the fitment or reprint the electronics box. If unsure, reach out on the Community Discord.
Manta M5P
- Install the BigTreeTech CB1/CB2 (or Raspberry Pi CM4) onto the Manta M5P using 4 M2.5 x 6mm screws.
- Following BigTreeTech’s instructions, flash your CB1/CB2 or Raspberry Pi CM4 with Klipper and your preferred Web UI, we can move onto flashing Kalico later.
Final Check
- Test that the CB1/2, or Pi CM4 boots, connects to your network and that you have access to your Web UI of choice. If all is good, we can move onto the next step.